Silicone Ice Cube Maker

Pull out the inner plastic cylinder, pour water into the silicone container, and position more than 2 racks should not exceed 2.5 racks. Slowly insert the inner barrel with the cover into the silicone cavity (pay attention to rotate and insert it at the bottom and hold it down, and then gently pinch the silicone side under the cover to vent the inner barrel to prevent the inner cylinder floats.)Put the mold at room temperature for a few minutes; If you don't want to wait and press hard, you can pour a proper amount of hot water into the inner cylinder, it will pour out the hot water in about 10 seconds, and you can easily take out the inner cylinder. Squeeze the outer wall of the silica gel and adjust the angle continuously to remove ice cubes.